When the window sticking machine is turned on, the motor has abnormal noise and the film cannot be sent:
1. Check whether the steering of the main motor is accurate, and adjust it to the exact direction indicated by the arrow;
2. Whether the motor driver is defective, turn off the main power supply of the window sticker and turn it on again to restore it to normal.
During the operation process, the film feeding specifications are criss-crossed, and the feeding specifications are more than 5mm shorter than the preset specifications. The processing method of not feeding the film once intermittently occurs during the operation of the window sticking machine:
1. The photoelectric eye sensitivity scheduling is not good or the polarity selection is wrong;
2. The photoelectric switch seat should be replaced if there is leakage to the ground or a short circuit between the terminals;
3. The discharging speed is lower than the feeding speed. It is necessary to relax each lamination bar, check some functions of the discharging, and clean the defects.
The torque of the motor has dropped significantly, and the bag making specification is inaccurate, indicating that the driver of the window sticking machine is defective, or the connection between the rubber roller of the window sticking machine and the motor is blocked.
